Procom music logo

G√• til hovedinnhold »

Søk i nettsted

Du er nå her:

Alctron CP540 V2

1-kanals kompessor basert på Neve 2254

Alctron CP540 V2
Varenr.: 114047
Lagerstatus: På lager
kr 3 495 inkl. mva. kr 2 796 eks. mva.
Legg varer i handlekurven
Flere Bilder Bookmark and Share

1-kanals kompessor basert på Neve 2254
CP540 V2-kompressoren er en kompressor i "vintage-style" med diskrete kretser som er basert på en Neve 2254. Den har en side-chain høypassfilter som kan settes til: 50Hz, 100 Hz eller 7 kHz. Dette gjør det mulig for brukeren å hindre at bassfrekvenser utløser komprimeringen, eller med 7kHz-innstillingen blir det en fantastisk de-esser. Du kan også stereokoble to CP540s sammen med en TRS-kabel, og gjøre CP540 til en flott stereokompressor for trommer, piano eller hovedbussen din! Denne funksjonen kan slås av på forsiden av kompressoren, slik at du enkelt kan gå tilbake til to monokompressorer uten å måtte koble fra kabelen. CP540-forholdet kan angis fra et mildt 1,5:1-forhold opp til en 6:1-innstilling.

Nøkkelfunksjoner:

  • Vintage style electronics
  • Based on classic diode bridge designs.
  • Transformer balanced I/O´s.
  • Separate in- and output XLR and TRS jacks for flexible connections
  • Frequency Response: 20 Hz 20 KHz +/- 0.5 dB.
  • Sensitivity: 20 dBu maximum at 1 Khz
  • Input impedance: 50K Ohms (Balanced)
  • Output impedance: 200 Ohms (Balanced)
  • Noise: Less than -80 dBu
  • Maximum Output Level: 20 dBu
  • Total Harmonic Distortion: <0.5% at 1 KHz, +4dBu
  • Possibility to Link two units for stereo operation
  • Great sound that suits most sound sources and genres.

CP540 Studio Compressor Limiter V2
The Alctron CP540-V2 is a pro compressor, based on the 2254 compressor found on Neve’s consoles. Ideal for adding a vintage sonic tone, it is fully discrete and transformer coupled. Independent compression and limiter. Tough high quality steel chassis.

High End Quality
This professional compressor has five filters that are switchable in the side chain. The range is 60HZ, 90HZ, 130HZ, 200 HZ, 440HZ. You can use these filters to customize the compressor to prevent frequencies from bass from triggering the compressor. There is an external side chain input on the CP540 which adds to your level of control. The result is smooth bus compression, the range of compression from 1:5:1 to 10:1.

Stereo Link Function
You can also stereo link two CP540s together with a TRS patch cable, turning the CP540 into a great stereo compressor for drums, piano, or your master bus. This feature can be switched off on the front of the compressor, so you can easily go back to dual mono compressors without the need to unplug the cable.

Features:

  • Independent Compressor + Limiter
  • Transformer coupled with an interstage transformer.
  • The circuit adopts high quality components to ensure low distortion and pure sound quality
  • Transistor based (discrete).
  • The chassis is made from high quality steel to provide extra shielding against stray magnetic and RF
  • High pass filter
  • Variable THRESHOLD, RATIO, ATTACK, RELEASE
  • Frequency response: 20hz-20khz
  • Noise: <-80dBu
  • Max output level: 20dBu
  • Compressor threshold: -20dBu to +16dBu with 2dB steps
  • Ratio: 1.5:1 to 10:1 with 6 position switch
  • Attack: 2mS to 80mS with 6 position switch
  • Recovery: 100, 200, 400, 800mS
    • Auto 1 100mS isolated peaks, 2 sec prolonged levels
    • Auto 2 50mS isolated peaks, 5 sec prolonged levels
  • Distortion: <0.5%@1khz, +4dBu
  • Limited threshold: +4dBu to +15dBu with 0.5 dB steps
  • Attack: slow 4mS, fast 2mS
  • Recovery: 100, 200, 400, 800mS
    • Auto 1 100mS isolated peaks, 2 sec prolonged levels
    • Auto 2 50mS isolated peaks, 5 sec prolonged levels
  • Gain make-up: 0 to +20dBu in 1dB steps
  • Input impedance: 50kohm balanced
  • Output impedance: 200ohm balanced